Specifications - Roland KC-500 Owner's Manual

Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Turn on the keyboard(s).
2. Turn on the main KC-500 amplifier.
3. Turn on the sub KC-500 amplifier.
4, Adjust the volume levels on all devices.
Before switching off the power, lower the volume on each of
the devices in your system and then TURN OFF the devices in
the reverse order to which they were switched on.
The jacks and knobs on the main amplifier work just like they
do during normal use, but the right-channel signals are out-
put from the internal speakers.
The volume knobs ([8]) for the different channels affect both
the main and sub amplifiers.
SPECIFICATIONS
Rated Power Output
Speaker Out 150 W
Phone Out 90 mW + 90 mW
(both channels 100 ohm loaded)
Nominal Input Level
INPUT
Channel 1,2,4 -20 dBm
Channel 3 -50 dBm
STEREO LINK IN 0 dBm
Nominal Output Level
STEREO LINK OUT 0 dBm
LINE OUT +4 dBm
0 dBm = 0.775 Vrms
Speakers
38 cm (15 inches) x 1 + Horn Tweeter x 1
Controls
Channel 1 Volume Knob
Channel 2 Volume Knob
Channel 3 Volume Knob
Channel 4 Volume Knob
Output Select Knob (Channel 4)
Phones Volume Knob
Low Knob
Middle Knob
High Knob
Volume Knob
Line Out Level Knob
On the sub amplifier, you can use only the STEREO LINK IN
jack and the four knobs ([11], [12], [13], and [14]) in the MAS-
TER CONTROL Section.
If you're using the Stereo Link function, make the adjustments
described below.
1. Use the Volume knobs in the CHANNEL CONTROL
Section of the main amplifier to adjust the volume balance
for each channel.
2. Use the four knobs in the MASTER CONTROL Section of
both amplifiers to adjust the main and sub volume and tone
quality.
Connectors
Channel 1 Input Jacks (L/ MONO, R)
Channel 2 Input Jacks (L/ MONO, R)
Channel 3 Input Jacks (L/ MONO, R)
Channel 4 Input Jacks (L/MONO, R)
Phones Out Jack
STEREO LINK Out Jack
STEREO LINK In Jack
Line Out Jacks
(XLR type balanced L, R, 1/4 inch phone type unbalanced
L/MONO, R)
Power Supply
AC 117 V, 230 V or 240 V
Power Consumption
125 W
Dimensions
590 (W) x 448 (D) x 591 (H) mm
23-1/4 (W) x 17-11/16 (D) x 23-5/16 (H) inches
Weight
31.5 kg/ 69 lbs 8 oz
Accessories
Owner's Manual
* In the interest of product improvement, the specifications
and/or appearance of this unit are subject to change with-
out prior notice.
For Europe