Sears CRAFTSMAN MilterMate 137.212260 Operator's Manual page 36

Bevel/Miter Settings
Fig. OO
Settings for standard crown
molding lying flat on compound
miter saw table
Inside Corner
OR
\
Outside Corner
NOTE: The chart below references
a compound cut for crown molding
ONLY WHEN THE ANGLE BETWEEN
THE WALLS EQUALS EXACTLY 90 °.
BEVEL
KEY SETTING
IL 33,9 °
IR 33.9 °
OL 33.9 °
OR 33.9 °
MITER SETTING TYPE OF CUT
Inside corner-Left side
31.6 ° Right t. Position top of molding against fence_
2. Miter table set at RIGHT 31.6 °.
3, LEFT side is f.,!nished piece. ,.......
Inside corner-Right side
3t .6_ Left t. Position bottom of melding against fence.
2. Miter table set at LEFT 31.6 °.
3. LEFT side is finished piece_
Outside comer-Left side
31,6 ° Left t. Position bottom of m0iding against fencel ...........
2. Miter table set at LEFT 31.6 °.
3. RIGHT side is finished piece.
Outside corner-Right side ......... ..............
31.6 ° Right t, Position top of molding against fence.
2. Miter tabfe set at RIGHT 31,6 °.
3. RIGHT side is finished piece.
36