Advertisement
2. Tighten the knob to the lock position
and remove the MiterMate
TM
angle
finder from the corner,
Adjusting the sliding fences for
miter angle setting (Fig, HH):
1. Place the angle copied MiterMate
TM
angle finder on the saw. Make sure
the fitting block (3 - Fig. FF) under
the angle finder is inserted into the
slot (4) through table.
2. Individually unlock the left and right
sliding fence units by unlocking the
positive stop lock lever (5) behind
the fence unit and lift up the lock
lever (6) pivotally connected in the
base.
3. Individually slide the left and right
sliding fence units toward the
paddles until each sliding fence
plate (7) flat against the paddle (8),
4, IndMdually lock the left and right
sliding fence units by flipping down
the Iock lever (6).
5, Remove the MiterMate
TM
angle
finder from the saw,
6. Respectively p_ace a base/crown
molding piece against the left and
right sliding fence units, and perform
the cross cutting to accomplish base/
crown molding cutting.
Fig. HH
7
/
6
Cutting crown molding:
Your miter saw is suited for making the
difficult task of cutting crown molding
easily. To fit properly, crown molding
must be cut with extreme accuracy.
The two surfaces on a piece of crown
molding that fit flat against the ceiling
and walt are at angles that, when
added together equat exactly 90 °, Most
crown molding has a top rear angle (the
section that fits flat against the ceiling)
and a bottom rear angle (the section
that fits flat against the wall). The
two common spring angles for crown
molding are: 52°/38 ° and 45°/45 °.
1. Determine the spring angle for the
crown molding, for example, 52/38
degrees as shown in Fig. II.
Fig. I1
Wall
Ceiling
iii
52 _
I
38 °
2. Measure the angle of corner by
angle finder and lock the sliding
fences unit in positions,
3. Place the crown molding piece
upside down with against the table
and the fence as shown in Fig. JJ.
(Think of the table as the ceiling.)
Fig. JJ
F-_
38°
iI__
lamp
s2"
Miter saw table
I
33
Advertisement
