Advertisement
Fig. DD
WORKPIECE SUPPORT AND
REPETITIVE CUTTING USING THE
STOP PLTAE (FIG. EE)
Long workpieces need to be supported
by the extension wing.
1. Slide the extension wing to desired
position and tighten the knob.
2. The stop plate (1) is designed for
use during repetitive cutting. Only
use one stop plate a time. To use
this function, simply rotate the stop
plate to vertical position.
Fig. EE
1
SETTING UP THE TABLES FOR
ANGLE CUTS USING THE ANGLE
FINDER (FIG. FF, GG)
The MiterMate
TM
accurate angle cutting
is suited to do with the fact that most
walls and ceiling are not 90 degrees to
each other, and so you can make the
accurate angles for fewer miscut and
quicker task completion.
Using the MiterMate
TM
angle finder
to copy a corner angle:
t. Unlock the MiterMate
TM
angle finder
by loosening the knob (1), open up
the paddles (2) to copy the corner
angle.
Fig, FF
a)
b)
For inside corner, adjust the
paddles to make the angle (X1)
between two paddles larger than
the inside corner angle(X2), and
then butt each paddle flat against
the wall surface.
For outside comer, adjust the
paddles to make the angle (Y1)
between two paddles smaller than
the outside corner angle (Y2), and
then utt each paddle fiat against
the wall surface.
Fig. GG
X2
Inside Corner
Outside Comer
32
Advertisement
