Sears CRAFTSMAN MilterMate 137.212260 Operator's Manual page 3

MOTOR
Power Source .................................................................... 120V, 60Hz, 15A
Speed ................................................................................ 4800RPM (No load)
Brake ................................................................................. Electric
Double Insulated ............................................................... Yes
BLADE SIZE
Diameter ............................................................................ 10 in.
Arbor size ........................................................................... 5/8 in.
ROTATING TABLE:
Diameter ............................................................................. 12-3/4 in.
Miter Detent Stops ............................................................. 0_,22.5°,45° R & L
Bevel Positive Stops .......................................................... 0, 45_ L
CUTTING CAPACITY-"
Crosscut ............................................................................ 2-5/8 in. x 5-9/16 in.
Miter 45 ° R & L................................................................... 2-5/8 in. x 3-!/2 in.
Bevel 45 ° L......................................................................... 1-9/16 in. × 5-9/16 in.
45 ° Miter and 45 ° Bevel ..................................................... 1-9/16 in. x 3-1/2 in.
Crown Molding ................................................................... 4-1/4 in.
WARNING t
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection.
This tool is wired at the factory for t 10-120 Volt operation. It must be
connected to a 110-120 Volt t 15 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these
safety rules. Failure to follow these rules could result in serious injury to
you or damage to the tool.
3