Samsung NZ84J9770EK User & Installation Manual page 97

Information code
C0
C1
C2
A2
d0
F0
F2
NZ84J9770EK_ET_DG68-00658A-00_EN.indd 45
Possible cause
Check the Auto Cook sensor.
The temperature is sensed higher
than specified.
Check the Auto Cook sensor.
The DC Motor fails to operate
because of problems with the PCB
or wiring, or electrical disturbance
on the motor blade.
The sensor is pressed for more
than 8 seconds.
Communications between main
and sub PCBs fail.
The touch-enabled IC
communicates abnormally.
Solution
Restart the appliance using the Power
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance and
try again. If the problem still continues,
contact a local service center.
Check if the sensor pad is wet or pressed.
If the problem continues, restart the
appliance using the Power button. If the
problem still continues, contact a local
service center.
Restart the appliance using the Power
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance. If
the problem still continues, contact a local
service center.
English 45
2/16/2015 5:35:01 PM