Table of Contents
Advertisement
Cable distance for Switch
If the "DIP Switch Mode" is set to
Note
If the "DIP Switch Mode" is set to "Ex-
Make sure the wiring is correct
Category 3/4/5 cable can be used in 10
Mbps operation. To reliably operate your
network at 100Mbps, you must use an un-
shielded twisted-pair (UTP) Category 5/5e
Note
cable, or better data grade cabling. While a
Category 3 or 4 cable may initially seem to
work, it will soon cause data loss.
Step 5: Supply power to the FSD-604HP.
A. Connect one end of the power cable to the
B. Connect the power plug of the power cable
When the Switch receives power, the power LED should
remain solid Orange.
"Standard", then the distance between
the FSD-604HP and PC/PD should not ex-
ceed 100 meters for UTP/STP cable.
tend", then the distance between the
FSD-604HP and PC/PD should not exceed
250 meters.
Switch.
to a standard wall outlet.
- 10 -
Advertisement
Table of Contents
