Appendix A: Epo Connection Steps - Panasonic EVERVOLT EVHB-I7 Installation And Operating Manual

Appendix A: EPO Connection Steps

Appendix A: EPO Connection Steps
For installing EPO on the inverter, follow the below installation instructions.
Step 1: Remove the factory-installed jumper from Pin 7 and 8 of the 8-
position "AUX" connector inside the inverter.
Step 2: Use minimum 24 AWG conductors to connect Pin 7 and Pin 8
(labeled "12V" and "STOP_NO") to a suitable emergency stop switch.
1
76
8
EPO
Appendix B: Meter Y Connection Diagram
Appendix B: Meter Y Connection Diagram
77