Table of Contents
Advertisement
Mechanical Installation
5.6.2 Mounting Steps
NOTE!
The mounting steps in the followings will take mounting on the
wooden wall spaced at 32 inch as an example.
NOTE!
Before mounting the inverter, the mechanical installation of the
whole battery must be completed.
Step 1: Fix the bracket
a) Two M4 holes are reserved on the BMS for fixing the bracket of the
inverter.
Ÿ
Screw in M4 screws to pre-fix the bracket on the BMS but be sure not to
tighten.
Ÿ
Hold the bracket firmly to the wall surface.
Ÿ
Tighten the M4 screws to fix the bracket on the BMS.
30
wall.
power drill, and make sure the holes are deep enough (2.1 in. / 55.0 mm) to
support the inverter.
M4
4.4 lbf.in /
0.5 N·m
b) Use the bracket as the template to mark the screw hole location on the
c) Unscrew the two M4 screws to disassemble the bracket. Drill holes with
NOTE!
The figure below is only used for showing the depth and location of
holes. Make sure the holes are in the center of each stud and keep
at least 1.5 in. / 38 mm away from the edge of concrete bricks or
studs before marking holes.
NOTE!
For solid concrete wall, please use
Mechanical Installation
Round holes
Φ4 drill
Depth:
2.1 in. / 55.0 mm
Φ10 drill.
31
Advertisement
Table of Contents
