Binding Process - THUNDER TIGER KT8 Instruction Manual

las
BINDING PROCESS
A binding feature is included in the ACE RC Cougar 2.4GHz spread spectrum system to ensure the transmitter
and receiver bind properly and prevent interference from other controllers.
To manually bind Tx/Rx, please proceed as per the following steps:
a. Press and hold the "Binding SW" button on the back side of the transmitter while turning on the transmitter.
b. Release the "Binding SW" button after the green LED flashes indicating the transmitter is binding.
C. Press and hold the bind button on the receiver while turning on the receiver. Binding process will then start
automatically. The LED will turn green/reed flash on the receiver.
d. Release the "Binding SW' button. Successful binding is confirmed by the binding LED changing from a quick
blinking and then remain solid on the transmitter. The LED will turn green on the receiver. Once binding is
complete, the system will automatically connect.
Note: Binding process may take 3~10 seconds to execute. If binding fails, the LED on the receiver will
turn red. Please turn off the power and repeat the steps from a) ~d).
Step TX Action RX Action LED
Swithch On / Push
No Action
No Action
LED: RED.
No Action
LED: GREEN
d No Action [ н
аны ез» |
\
TX LED : GREEN FLASH
RX LED : GREEN/RED FLASH
TX LED:
GREEN FLASH->GREEN SOLID
RX LED :
RED SOLID-->GREEN SOLID