Table of Contents
Advertisement
5
BINDING PROCESS
A binding feature is included in the ACE RC Cougar 2.4GHz spread spectrum system to ensure the transmitter and receiver
bind properly and prevent interference from other controllers.
To manually bind Tx/Rx, please proceed as per the following steps:
a. Press and hold the "Binding SW" button on the back side of the transmitter while turning on the transmitter.
b. Release the "Binding SW" button after the green LED flashes indicating the transmitter is binding.
c. Press and hold the bind button on the receiver while turning on the receiver. Binding process will then start automatically.The
LED will turn green/reed flash on the receiver.
d. Release the "Binding SW" button. Successful binding is confirmed by the binding LED changing from a quick blinking and then
remain solid on the transmitter. The LED will turn green on the receiver. Once binding is complete, the system will automatically
connect.
Note ! Binding process may take 3~10 seconds to execute. If binding fails, the LED on the receiver will turn red.
Please turn off the power and repeat the steps from a) ~d).
ACE RC Cougar PS3i
a.
b.
LED
c.
d.
"Binding SW"
Step
Swithch On
a
b
Release
c
d
3 2.4GHz
"Binding SW"
"Binding SW"
"Binding SW"
LED
3~10
a)~d)
TX Action
/ Push
Swithch On
No Action
No Action
Release
(
RX Action
No Action
No Action
/ Push
RX LED
RX
TX LED
GREEN FLASH-->GREEN SOLID
RX LED
RED SOLID-->GREEN SOLID
TX
RX
)
LED
LED
LED
LED
_
TX LED
GREEN FLASH
TX
GREEN/RED FLASH
/
-->
-->
Advertisement
Table of Contents
