Table of Contents
Advertisement
las
1.1 CHARGING THE BATTERY PACK
(Battery & charger are not included)
1. When charging the battery, first plug the adapter connector into the charger. Connect the adapter connector to the battery
pack. Confirm the link between charger, adapter connector and battery pack that are properly connected in order. You can
connect the charger to the AC wall outlet now.
2. Once the charger is connected, a red LED will light up to indicate that the charging has begun. The LED will light up green to
indicate that charging is completed.
3. When finished charging, first disconnected the charger from the AC wall outlet. Disconnect the battery pack from the charger.
Install the battery pack on your vehicle.
a. Disconnect the battery connector then squeeze the battery tray tabs towards each other to allow the battery tray to slide
underneath the chassis.
b. Place a fresh battery pack along with the foam spacer onto the battery tray then slide it up from under the chassis until the
battery tray tabs lock into place.
(Always install the foam spacer with the battery as this acts as a spring to keep the locking
tabs in place.)
c. Finally, reconnect the battery connector.
BATTERY PLACEMENT
TA AO.
d
]
BATTERY FRONT
BATTERY BACK
is
{ |
Li
|
|
For most cases гип the battery in the rearward position (foam spacer towards the front). Typically this will be the most stable and
easiest to drive. Try moving the battery forward if the track surface has better traction.
Advertisement
Table of Contents
