Bosch Nexxt 100 Series Operating, Care And Installation Instructions Manual page 21

Fault
Suds coming out of the
detergent dispenser.
Repeatedspinning.
Thelaundrywas not
spun.
Program duration ex-
tended.
Unsatisfactorywashing
result.
Detergent residue on the
laundry.
Gray residue on the laun-
dry.
Systemshakesor shudders
whenpassing from lowerto
higherspeedspinning.
Possible cause
Too much soap or non-HE soap used, pump could
not remove suds.
This is not a fault.
The imbaiance compensation system is attempting to
balancethe load through repeated spins.
Large items of clothing have become entangledand
could not be distributed evenly in the drum. For safe-
ty reasons the high-speed spin cycle was automati-
cally suppressed.
This is not a fault.
The suds detection feature has activated an addi-
tional rinsing cycle to reducethe amount of suds.
This is not a fault.
The imbaiance compensation system is attempting to
balancethe load through repeated spins.
The degree of soiling was higher than estimated.
Not enough detergent.
Some phosphate-free detergents contain water-insol-
uble residues that may appear as light spots on the
laundry.
Dirt accumulation from ointments, fats or oils.
Drumsystemsuspension can shift duringspeedup,this
is not a failure.
Action
Mix 1 tablespoon of fabric softener with 1 pt (_/sIitre)
of water and pour into detergent dispenser III.
Use less detergent for future wash loads. Detergents
specifically designedfor you High Efficientcy washer
produce fewer suds and will include the letters "HE"
on the packaging.
Always load the drum with large and small items
together.
Always load the drum with large and small items
together.
Add a more appropriate amount of detergent.
Always load the drum with large and small items
together.
Select suitable program
Add detergent according to the manufacturer's
specifications.
Brush off spots when laundry is dry.
Add the maximum amount of detergent and select
the highest permissible temperature.
Mix smalland largelaundrypiecesin load to minimize
this effect.
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the appliance on
again, select and start the program. If the fault continues, call customer service; see Page 22.
21