External Touchscreen - Crestron TPS-GA-TPI Operation Manual

®
Isys G-Series Touchpanel Interface
®
32 • Isys
G-Series Touchpanel Interface: TPS-GA-TPI
NOTE: For optimum performance, Crestron strongly recommends using Crestron
Certified CresCAT-QM cable, available from Crestron. Other high-quality/low skew
CAT5e/CAT6 wiring may also be used with varying performance.
NOTE: The maximum continuous current from equipment under any external load
conditions shall not exceed a current limit that is suitable for the minimum wire
gauge used in interconnecting cables. The ratings on the connecting unit's supply
input should be considered to prevent overloading the wiring.
NOTE: Sound in downloaded WAV format and key click are sent to the headphone
and QuickMedia output.
NOTE: Ensure the unit is properly grounded.
If using the QM OUT port on the TPS-GA-TPI, attach the included bead to a
shielded CAT5e cable with a single turn. As shown in the illustration below, the
bead should be located one inch (2.54 cm) from the cable's end.
CAT5e cable with Bead Attached

External Touchscreen

There are six external non-Crestron touchscreens that will work with the
TPS-GA-TPI. Each can be connected via serial connection or USB. The connection
procedures are similar for all of them.
There are two commands that must be executed at the command line interface
provided by the Toolbox Text Console.
Crestron TPS-GA-TPI
Operations Guide – DOC. 6609A