Removing The Mower Deck - Toro 74661 Operator's Manual

2
1
Figure 67
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here
3
2
G009659
Figure 68
Mower Decks with 3 Blades
1. Blades front to rear
2. Outside cutting edges
5. Measure from the tip of the front blade to the flat
surface, and the tip of the rear blade to the flat surface
(Figure 67 and Figure
Note: If the front blade tip is not 1.6 to 7.9 mm (1/16
to 5/16 inch) lower than the rear blade tip, adjust the
front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower
G009658
2
1
2
3
3. Measure from the tip of the
blade to the flat surface
here.
68).
(Figure
g009658
1
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
8. To lower the front of the mower, loosen the adjustment
nut.
g009659
9. After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (Figure 67
10. When the front-to-rear blade slope is correct check the
side-to-side level of the mower again, refer to
from Side to Side (page

Removing the Mower Deck

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
69).
3. Lower the height-of-cut lever to the lowest position.
4. Loosen the bottom 2 bolts holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page
5. Remove the hairpin-cotter pin from the front support
rod, and remove the rod from the deck bracket
70).
45
3
2
G014634
Figure 69
3. Locknut
and Figure 68).
43).
Releasing the
31).
g014634
Leveling
ARK
(Figure