Table of Contents
Advertisement
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
a rag.
Note: Make sure to scrape any paint off the front of
the fitting(s).
Figure 38
1. Front caster tire
Figure 39
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check the tire pressure
every 25 operating hours.
4. Connect a grease gun to each fitting
Figure
39).
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
ARK
(Figure 38
and
Figure
39) with
decal106-8717
3. Grease every 25 operating
hours.
4. Engine
(Figure 38
and
Engine Maintenance
Engine Safety
Shut off the engine before checking the oil or adding oil to
the crankcase.
Servicing the Air Cleaner
Service Interval: Before each use or daily
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Removing the Elements
1. Park the machine on a level surface and disengage the
blade-control switch (PTO).
2. Engage the parking brake, shut off the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean around the air-cleaner cover to prevent dirt from
getting into the engine and causing damage.
4. Lift the cover and rotate the air-cleaner assembly out
of the engine
g032432
32
(Figure
40).
g027800
Figure 40
g027800
g027801
g027801
Advertisement
Table of Contents
