Cleaning Agent; Suitable Cleaning Agents - Siemens CS656GB 2W Series Instruction Manual

Table of Contents

Advertisement

descale it with a message on the display. The number
of remaining operations is displayed after the appliance
is switched on. You can therefore prepare for the
descaling in good time.
Starting
Caution!
Risk of damage to the appliance: Only use liquid
descalers recommended by us for the descaling
programme. The time the product needs to work
during descaling depends on the type of descaler
used. Other descalers may damage the appliance.
Descaler order no. 311 680
Descaling solution: Do not allow any descaling
solution or descaler to come into contact with the
control panel or other surfaces on the appliance.
This damages the surfaces. If this does happen,
remove the descaling solution immediately with
water.
If you have used a steam-assisted operation
immediately before descaling, you must first switch the
appliance off so that the residual water is pumped out
of the evaporator system.
Mix 400 ml water with 200 ml liquid descaler to
1.
make a descaling solution.
Press the
button.
k
2.
Remove the water tank and fill it with descaling
3.
solution.
Once the water tank has been filled with descaling
4.
solution, push it back in again fully.
Close the control panel.
5.
Press the
button.
j
6.
The operating modes menu opens.
Select the "Descaling" operating mode.
7.
If you touch the "Next" field, information on the
cleaning operation is displayed.
The duration of the descaling programme is
displayed. It cannot be changed.
Press the
button to start the cleaning function.
u
8.
The appliance is now descaled. You can see the
duration counting down in the status bar. As soon as
the descaling programme has finished, an audible
signal sounds.
First rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Use the
button to start.
u
4.
The appliance rinses. As soon as the wash cycle has
run through, a signal sounds.
Second rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Use the
u
button to start.
4.
The appliance rinses. As soon as the wash cycle has
run through, a signal sounds.
Subsequent cleaning
Open the control panel.
1.
Empty and dry the water tank.
2.
Switch off the appliance.
3.
Descaling is complete and the appliance is ready for
use again.
DCleaning agent
W ith good care and cleaning, your appliance will retain
C l e a n i n g a g e n t
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.

Suitable cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Depending on the appliance
model, not all of the areas listed may be on/in your
appliance.
Caution!
Risk of surface damage
Do not use:
Harsh or abrasive cleaning agents,
Cleaning agents with a high alcohol content,
Hard scouring pads or cleaning sponges,
High-pressure cleaners or steam cleaners,
Special cleaners for cleaning the appliance while it is
hot.
Wash new sponge cloths thoroughly before use.
Highly recommended cleaning and care products
Tip:
can be purchased through the after-sales service.
Observe the respective manufacturer's instructions.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
Area
Cleaning
Appliance exterior
Stainless steel
Hot soapy water:
front
Clean with a dish cloth and then dry with a soft
cloth.
Remove flecks of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corrosion
can form under such flecks.
Special stainless steel cleaning products suitable
for hot surfaces are available from our after-sales
service or from specialist retailers. Apply a very
thin layer of the cleaning product with a soft cloth.
Plastic
Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use glass cleaner or a glass scraper.

Cleaning agent

en
25

Advertisement

Table of Contents
loading

Table of Contents