Table of Contents
Advertisement
3) Setting of a day of the week
"dAy" sign is shown on the display and all of a day of the week blink.
Press the "▲MIN." button or the "▼HOUR" button to set a day of the week. A day of the week will blink. (Initial
setting is "SUN".) The other days of the week will go off. Select a day of the week by using the "▲MIN." or the
"▼HOUR" button. When pressing the "▲MIN." button, the sign will change as follows.
"SUN" ➞ "MON" ➞ "TUE" ➞ "WED" ➞ "THU" ➞ "FRI" ➞ "SAT"
When pressing the "▲MIN." button at the position of "SAT", you can hear the beep sound and "SAT" is not
changed any more. When pressing the "▼HOUR" button, the sign will change as follows.
"SAT" ➞ "FRI" ➞ "THU" ➞ "WED" ➞ "TUE" ➞ "MON" ➞ "SUN"
When pressing the "▼HOUR" button at the position of "SUN", you can hear the beep sound and "SUN" is not
changed any more.
Press the "SET" button to complete the set of a day of the week. The current time and a day of the week will
show on the display.
NOTE: If the ON/OFF switch is pressed during resetting of the current time and a day of the week after setting
the time and a day of the week, the set mode of the current time will terminate and the operation will start. If a
day of the week is set, the time is fixed at the resetting time. If a day of the week is not set, the contents of the
setting are deleted.
MANUAL OPERATION
Operation of the heater is under the direct control of the user. Heat output will, however, be automatically
adjusted in accordance with the room temperature registered by the temperature sensor.
1. Turning Heater ON
A. Press ON/OFF switch to "ON" position. The current room temperature and the set temperature will be
shown on the digital indicator. ON lamp will start to flash and then blower motor and ignition will start. This
lamp will continue to flash during the preheating time.
B. After approx. 1.5 – 4 minutes ignition will take place. (*) After ignition, ON lamp will change flashing to
continuous. Circulation fan will turn on after approx. 2 minutes.
NOTE: (*) Pre -heating depends on the room temperature.
Room temperature:
under 0˚C 4
0˚C - 15˚C 2
15˚C
OPERATION
minutes
minutes
1.5 minutes
8
Advertisement
Table of Contents
