Installation Of Heater And Flue Pipe - Toyotomi FF V30 Operation Instructions Manual

Vented heating system

Hide thumbs Also See for FF V30:

Operating manual (67 pages)

Operating manual (152 pages)

Table of Contents

Before commencing any installation work, check that the proposed installation will comply with Building Code

requirements and Local Consent Authority rules that may apply to vented heaters in your area. (Check your

Local Authority website, or consult your Installer / Supplier.)

The Flue Pipe is designed to be installed through the wall of any conventional building cladding, including

Brick, Hebel, Linear, Gibraltar and Plaster Board, Tiles, Weatherboard, Plastered Polystyrene, and metal

profiles etc.

The FF V30 heater is designed to be operated at altitudes up to 900 m, above sea level. For installation at alti-

tudes between 900 m and 1800 m, adjustments by authorized serviceperson is necessary. Consult your sup-

plier for advice.

Select heater location. Ensure minimum clearances as indicated below between heater and nearest

combustible materials. (See Fig. 1.) Provide service access to clean the circulation air filter, integral fuel strainer

and reset button.

Ensure the outdoor flue discharge area is clear of anything that might be affected by the hot flue exhaust gas.

(See Fig. 2 and 3.)

The Flue Pipe (as in Fig. 2), is for wall thickness from 130 mm to 320 mm.

Flammable object

Not less than 60 cm