Supermicro X13SCL-IF User Manual page 82

Super X13SCL-IF User's Manual
SATA And VROC Configuration
SATA And VROC Configuration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and Enabled.
*If this feature is set to Enabled, the following features will become available for
configuration:
SATA Mode Selection
Use this feature select the SATA mode. Select AHCI to configure an sSATA drive specified
as an AHCI drive. The options are AHCI and Intel VROC SATA RAID.
SATA Interrupt Selection (Available when "SATA Mode Selection" is set to Intel
VROC SATA RAID)
Use this feature to select the interrupt that will be available to the operating system. The
options are MSI-x, MSI, and Legacy.
Support Aggressive Link Power Management
This feature enables the PCH to aggressively enter link power state. The options are Disabled
and Enabled.
Serial ATA Port 0–5 Hot Plug
This feature designates the specified port for hot plugging. Set the setting to Enabled for hot-
plugging support, which will allow you to replace a SATA disk drive without shutting down the
system. The options are Disabled and Enabled.
Serial ATA Port 0–5 Spin Up Device
When this feature is disabled, all drives will spin up at boot. When this option is enabled, it will
perform Staggered Spin Up on any drive this option is activated. The options are Disabled
and Enabled.
Serial ATA Port 0–5 SATA Device Type
Use this feature to identify the type of HDD that is connected to the SATA port. The options
are Hard Disk Drive and Solid State Drive.
PCH-FW Configuration
The following PCH-FW information is displayed:
• Operation Firmware Version
• Backup Firmware Version
82