Table of Contents
Advertisement
2.3 Motherboard Installation
All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Tools Needed
Torque Driver
(1)
MH1
JWD1
USB4/5 (3.2(5Gb))
JPME2
MH3
Location of Mounting Holes
Note 1: Do not use a force greater than 8 in-lbf (0.904 N-m) on each mounting screw
during motherboard installation. Exceeding this force may over-torque the screw, caus-
ing damage to the motherboard and screw.
Note 2: Some components are very close to the mounting holes. Take precautionary
measures to avoid damaging these components when installing the motherboard to
the chassis.
Phillips Screws
JUIDB1
JPL1
VGA
JPL1:LAN1
1-2:ENABLE
2-3:DISABLE
BMC
Controller
JMD1_SRW1
JPL2:LAN2
1-2:ENABLE
2-3:DISABLE
JMD1
JTPM1:TPM/PORT80
JWD1:WATCH DOG
1-2:RST
2-3:NMI
JPME2:
1-2:NORMAL
2-3:ME MANUFACTURING MODE
C262
JSLIM2
PCIe 4.0 x4
(4)
USB2/3 (3.2(5Gb))
BMC_LAN
LAN1/2
USB0/1
CPU
BIOS LICENSE
BT1
BAR CODE
I-SATA4
I-SATA5
JSLIM1
JL1: CHASSIS INTRUSION
PCIe 4.0 x4 / SATA x4
27
Chapter 2: Installation
Standoffs (4)
Only if Needed
COM1
JPW2
MH2
JF1
FAN2
FAN1
MH4
JNS1:
1-2: SATA
2-3: NVMe
Advertisement
Table of Contents
