Sound; Devices - Philips 56PFL9954H - User Manual

• Verify that the correct TV system is chosen in
the Manual installation menu.
• If only a certain channel is poor, try to fi ne
tune this channel with the Fine tune menu.
Read 4.2.5 Manual install - analogue.
The picture has poor colour
• Verify the colour settings in the Picture menu.
Select any of the Smart settings in the Setup
menu.
• Verify the connections and cables of the
connected devices.
Picture delay when a game console is connected
• To prevent picture delay, set the TV to game
mode. Select Game in the Smart settings in the
Setup menu.
The TV does not remember my settings when I
switch it back on
• Check whether the TV is set to Home in
the Home menu > Setup > Installation >
Preferences > Location menu.
The picture does not fi t the screen; it is either
too big or too small
• Press f and select a more fi tting picture
format in the Picture format menu.
The picture position on screen is not correct
• Some picture signals from some devices do
not fi t the screen properly. You can move the
picture with the cursor keys on the remote
control. Check the signal output of the device.

6.5 Sound

There is a picture but no sound
• Verify the volume is not set to 0.
• Verify the sound has not been muted with m.
• Verify that all cables are connected properly.
• If no sound signal is detected, the TV
automatically switches off the sound. This is
proper operation and is not a malfunction.
68
UM_Bombay_56PFL9954_en.indd 68 UM_Bombay_56PFL9954_en.indd 68
The sound is poor
• Verify that the sound is set to Stereo.
• Select any of the Smart settings in h > Setup
> Smart settings.
The sound comes from one speaker only
• Verify that the Balance is not set to extreme
left or right.
Sound delay when a DVD Home Theatre
System device is connected
• Read the user manual of the DVD device to
adjust the audio sync delay. If you cannot set a
delay, switch off HD Natural Motion in h >
Setup > Picture > Perfect Pixel HD.

6.6 Devices

HDMI connections
• The HDMI-HDCP procedure might take a few
seconds before the TV shows the picture from
a device.
• If the TV does not recognise the device and
the screen shows no picture, try switching
from one device to another and back again to
restart the HDCP procedure.
• If sound interruptions occur persistently, see
the user manual of the device to verify the
output settings. If that does not help, connect
an additional audio cable.
• If a DVI to HDMI adaptor is used, verify that
an additional audio connection is in place to
complete the DVI connection.
HDMI with EasyLink
• Verify if the connected device supports the
HDMI-CEC standard and is properly set up.
Read the user manual that comes with the
device.
• Verify if the HDMI cable is properly connected.
• Verify if EasyLink is activated in h > Setup >
Installation > Preferences >EasyLink.
• Make sure that the System audio control in
your HDMI-CEC audio devices is properly set
up. Read the user manual that comes with your
audio device.
2009-06-30 10:19:57 2009-06-30 10:19:57