Table of Contents
Advertisement
MS-6728 ATX Mainboard
Set Super I/O
Press <Enter> to enter the sub-menu and the following screen appears:
OnBoard FDC
Select Enabled if your system has a floppy disk controller (FDD) installed
on the system board and you wish to use it.
Option
Description
Auto
BIOS will automatically determine whether to enable the
onboard Floppy controller or not.
Enabled
Enables the onboard Floppy controller.
Disabled
Disables the onboard Floppy controller.
Onboard Serial Port A/B
These items specify the base I/O port addresses of the onboard Serial
Port 1 (COM A)/Serial Port 2 (COM B). Selecting Auto allows AMIBIOS
to automatically determine the correct base I/O port address. Settings:
Auto, 3F8/COM1, 2F8/COM2, 3E8/COM3, 2E8/COM4 and Disabled.
Serial Port B Mode
This item sets the operation mode for Serial Port B. Settings: Normal,
1.6uS, 3/16 Baud and ASKIR (the last three operation modes are
settingoptions for IR function).
IR Duplex Mode
This setting controls the operating mode of IR transmission/
reception. Setting options: Full Duplex, Half Duplex. Under Full
Duplex mode, synchronous, bi-directional transmission/reception
is allowed. Under Half Duplex mode, only asynchronous, bi-
directional transmission/reception is allowed.
3-26
Advertisement
Table of Contents
