Kenmore 911.93551 Owner's Manual page 3

IMPORTANT S AFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Read all instructions before using this appliance. When using
gas or electrical appliances, basic safety precautions should
be followed, including the following:
• All Ranges Can Tip
• Injury to Persons
Could Result
• Install AntiTip
Device Packed With
= Range
• See Installation
Instructions
Tools you will need:
• Phillips head screwdriver
, 1% open end or adjustable wrench
t. Remove the bracket from the
prepack located inside the oven
2. Decide whether the bracket will be
installed on the right or left side of
range location
3. If the bracket side of the range is
adjacent to a cabinet place the
bracket against back wall and
cabinet as shown in Fig 1
If there is no adjacent cabinet
determine where the location of
the range side (painted outside
panel) will be Place the bracket
with its outside edge at this
location and against back wall
See Fig 2
4. Determine whether you will anchor
the bracket to the floor or wall
Make sure this location is clear of
electrical wiring or plumbing
Outside Edge Of
Bracket To Be
Flush With Left Or
Right Side Of Range
Fig. 1
1
Fasten the bracket securely with
the screws provided Screws are
self drilling in wood plywood
particle and chip board and most
metal framing If attaching to
masonry you can buy suitable
screws and anchors at hardware
stores Use a masonry drill bit to
drill the required holes°
Bracket I1 Wall
Screw Must Enter \ I1 Plate
Wood Or Metal _11/
Fig. 2
Attachment To Wall
a
m
Using the wrench back out the
four leg levelers at least two turns
See your installation guide for
more leveling information before
positioning range
Slide the range into place Be sure
rear leg leveler fully engages the
slot in the bracket If range cannot
be moved back far enough for
rear leg leveler to enter bracket
move bracket forward as required
and attach to floor in new location
3