To Work Accessory Devices; Code Setup - Philips 42-LCD FLAT HDTV PIXEL PLUS 2 HD 42PF9830A User Manual

2496.1 16x24 en 14-12-2005
Setting the remote control to work accessory devices
Your TV remote control gives you the opportunity to control all your accessory devices with one single
remote control.This can be done by selecting the correct brand and type out of the list of Direct Entry
codes for accessory devices.
Press the button repeatedly to select
SELECT
accessory device you want to operate with this remote control. See Use of the Remote control, p. 8.
If the function buttons on the remote control also work the selected accessory device, then the remote is
ready and no further steps are needed.
If the function buttons do not work with the selected accessory device, according to the device(s) you
own, you may make your remote control ready for them by a direct entry code. Proceed as following.
POWER
DVD/R CBL TV VCR AUX
A/CH SELECT TV GUIDE
DEMO CLOCK
MY CONTENT
®
OK
®
®
MENU
+
VOL
MUTE
-
_-
ABC
1 2
GHI JKL
64
10:11 Pagina 64

Code setup

& Press the
SELECT
to the accessory device you want to operate with this remote control.
é Press the
SELECT
than 4 seconds.The selected mode LED will lit constantly.
"
Input the digit code for the type and brand of accessory device.
The codes are listed on page 65.
'
The selected mode LED will blink fast for 5 seconds as a confirmation
you entered a correct code.The remote will go back to the last
selected mode.
If you entered a wrong code the mode LED will stay on for 2 seconds.
INFO
Redo step "
(
Now you will try to use the TV remote with the accessory device.
Press the
SELECT
®
The selected mode LED will stay on for 2 seconds and then begin
blinking.The blinking means that the remote is in the accessory mode
you have selected.
§
PIP Within 60 seconds from the time the blinking starts, point the remote
toward the accessory device and press the
+
device does not respond to the
CH/ programming the remote again using a different setup code for the type
PAGE
and brand of accessory device you wish to operate. Refer again to the
-
code list on page 65. If no more codes are listed for the type and brand
DEF
of accessory device, the remote likely will not operate your particular
3
model of accessory device.
MNO
Notes:
- Your TV remote is not necessarily capable of being programmed to operate all
models of the brands of accessory devices listed on page 65.You may want to
try the programming process again. Try using the number(s) that are listed for
your type and brand of device to be sure you did not make a mistake in
inputting the digits during your first attempt at programming.
- If the remote control is in one of the accessory modes (a mode light is flashing)
— DVD/R, CBL, TV, VCR or AUX — and you don't press any of the remote
buttons for sixty seconds, a "time-out" occurs, returning the remote to TV mode.
To cancel the selected mode
Press the
SELECT
The remote control will return to TV mode.
, , or
DVD/R CBL (SAT) VCR
button repeatedly to select your source according
and button at the same time for longer
POWER
.
button repeatedly to select the desired mode.
POWER
button for 2 seconds.
according to the
AUX (CDR)
button. If the
POWER
command, follow the steps for