Fujitsu DL7400Pro User Manual page 128

USING SETUP MODE
5-40
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST Options
Items
<FCNTLOR>
0/9, 1/9, 1.8/9,
2/9, 3/9, 4/9, ...,
15/9
<FCNTLFN>
0/90, ..., 29/90
<RCNTLOR>
0/9, 1/9, 1.8/9,
2/9, 3/9, 4/9, ...,
15/9
<RCNTLFN>
0/90, ..., 29/90
<CUTLOR>
0/9, 1/9, 1.8/9,
2/9, 3/9, 4/9, ...,
15/9
<CUTLFN>
0/90, ..., 29/90
Description
It is possible to fine-tune the left blank
of the front continues form (the amount
of between the left paper edge to the
first dot for the first character).
This setting is effective only for the
front continues form at < FCNT-
SF:ENABLE >.
It is possible to fine-tune the left blank
of the front continues form by every
1/90 inches.
It is possible to fine-tune the left blank
of the back continues form (the amount
of between the left paper edge to the
first dot for the first character).
This setting is effective only for the
back continues form at < RCNT-
SF:ENABLE >.
It is possible to fine-tune the left blank
of the back continues form by every
1/90 inches.
It is possible to fine-tune the left blank
of the cut sheet paper (the amount of
between the left paper edge to the first
dot for the first character).
This setting is effective only for the cut
sheet paper at < CUT-SF:ENABLE >.
It is possible to fine-tune the left blank
of the cut sheet paper by every 1/90
inches.
User's Manual