Changing Print Position Adjustment Options - Fujitsu DL7400Pro User Manual

USING SETUP MODE
CHANGING PRINT
POSITION
ADJUSTMENT
OPTIONS
5-34
When you print using ruled paper, you often want to adjust the print
position so that the print sits properly on the ruled lines. The ADJUST
function allows you to:

Set top-of-form position

Fine-tune top-of-form position

Fine-tune left print start column (left margin)

Adjust for accumulative line spacing error in a page
The top edge of your paper is the physical top of the page. The logical
top of the page, as "understood" by the printer when loading paper, is
called the top-of-form. Printing starts at this position. Note that printing
actually starts at the position obtained by adding the following:

Top-of-form, default = 1.8/6 inch (7.6mm)

Top margin specified by your software

Printer TOP-MRG (top margin setting), default = 1 line
Table 5.5 describes the ADJUST items and options. Items are listed in
the order they are printed. The procedure for changing top-of-form is
described after Table 5.5.
User's Manual