Roland RD-600 Owner's Manual page 55

4. Press the [INC/ YES] button.
The display will ask you to confirm the operation.
Welk
Cure
Sure?
5.Start recording on your sequencer.
6.Press the [INC/YES] button once again, and exclusive data will be transmitted from the RD-
600. To cancel the operation press the [DEC/NO] button.
7.When transmission is finished, the display will indicate Complete!
Stop recording on your sequencer.
Receiving exclusive data from a sequencer
Restoring the factory settings (Initialize Current / Initialize All)
Initialize All will restore (initialize) all parameters of the RD-600 to their factory settings. The
contents of all setup memories will also be initialized.
Initialize Current will initialize the settings of the local parts, internal parts, and Tones. All 128
of the internal Tones will be initialized. However since the contents of the setup memories will
not be initialized, Tone settings that are saved in the setup memories will not be initialized.
1.Press the [EDIT] button. The indicator will light, and you will enter Edit mode.
The following display will appear.
Winitialize Winitialize oD
Current All
Initialize Current display Initialize All display
3. Press the [INC/ YES] button.
A message will appear in the display, asking you to confirm the operation.
Winitislize
Sure?
55