Transmitting; W Setting Transmission Output Level - Alinco DJ-V5T/E Instruction Manual

20
2-5 Transmitting
Basic Operation
1 Set the transmission frequency. (page 16)
2 Set the transmission output level.
3 Transmit the signal.
1. Check the transmission frequency and output level, and hold the
PTT key down.
2. Speak into the microphone when TX/RX lamp lights red.
3. When you release the PTT key. the transceiver will revert to
reception.
ome
eolee
2328
oc
Microphone
Note: While transmitting, the receiver does not operate.
A Caution: Before transmitting, confirm other stations are not
using the same frequency as yours.
@ SettingTransmission Output Level
1. Press the FUNC/LOCK key, then the 6(PQ) key. The
transmission output level will be shown.
"PHA HT &
"HI" flashes
The default setting is HI.
2. Use the 6(PO) key and the Dial, or &/W keys to select the
transmission output level from Hi, L1, and L2
H1 is the strongest, and L2 is the weakest. Depending on the
transmission output level, power consumption varies.
3. Press the PTT key to complete the setting. The display returns to
the frequency display.
The quantity of the ovals in the S Meter shows the transmission
output. When 6 ovals are indicated, the output is HI. When 3 ovals
are indicated, the output is LI. When 2 ovals are indicated, the
output is L2.
Reference:
Auto Temp (AT) Function
if the transceiver gets overheated, the ourput level
automatically switches to L2.
"AT" appears on the display. When the transceiver
cools down, "AT" disappears and the transceiver
returns to the previous Setting.