Table of Contents
Advertisement
@ Loading Batteries
1. Release the catches on the
battery case, and lift the battery
case up and off.
2. Load four commercially
available AA alkaline batteries.
3 Set the batteries in the battery
case in the [4] [E] orientation
marked at the bottom of the
case.
4. Fit the catches at end of the
battery case.
§. Push the battery case until it
clicks into place.
Note:
Do not use AA Ni-Cd batteries on the market.
@ Exchanging the Batteries
Use new batteries of the same type (e.g. : alkaline) and brand.
The DJ-V5 is a high output transceiver.
Alkaline batteries are recommended for use over extended periods of
time.
Reference:
+ Auto Power Off (page 32), Battery Save ( page 32)
These functions extend battery life.
@ Battery Recharger (EDC-93(120V), EDC-94(230V))
+ Recharging with the EDC-93(120V), EDC-94(230V)
1. Mount the Ni-Cd battery pack
on the transceiver.
2. Connect AC adapter plug to the
external power supply jack on
the transceiver
3. Connect to the AC outlet.
AC adapter plug
A
Caution:1
2
3
Turn the transceiver power off before recharging
the battery pack.
Disconnect the EDC-93/94 from the outlet while
not using it.
Never charge battery packs of other
manufacturers with this charger.
The required recharging time depends on the
condition and model of battery pack. Refer to the
instruction manual of the battery pack.
Never short-circuit the recharging terminals of
this recharger with metal objects, etc. The
charger can be damaged.
The EDC-93/94 does not work when the voltage
from the wall outlet is extremely low.
Advertisement
Table of Contents
