HP 1670A Series User Manual page 58

Example
Programming the Logic Analyzer
To copy commands to \system\program
To copy commands to\
system\program
1 Access the logic analyzer's file system as the control user.
Refer to the chapter "Accessing the Logic Analyzer File System".
2 Copy program command text to the logic analyer's
\ system\program file.
When the file system is NFS-mounted to your computer's file system, you can:
• Re-direct the output of an echo command to the \system\program file.
• Copy a text file containing a series of commands to the
\system\prograrn file.
When accessing the file system via ftp, you can:
• Use ftp's put command to copy a text file containing a series of
commands to the \system\program file.
Programming the logic analyzer over an NFS mount line-by-line
Suppose machine 1 is configured as a state analyzer. To clear its trigger
set-up, enter the following echo commands at the MS-DOS prompt:
echo :SELECT 1
>
L:\system\program
echo :MACHINEl:STRIGGER:CLEAR ALL
>
L:\system\program
The first command selects the analyzer. The second command clears the
trigger for machine 1.
If
your computer runs the UNIX operating system, you can use the UNIX
echo command.
5-7
I