Table of Contents
Advertisement
Al EDIT RECORDING
|
Opmmoo
ced
C2
The Al edit function enables CD recording without worrying about
cassette tape length and track length. When a CD is inserted,
the unit automatically calculates track lengths. If necessary, the
order of tracks is rearranged so that no track is cut short.
(Al: Artificial Intelligence)
NOTE]
* Al edit recording does not perform from a point halfway in the
tape. The tape must be recorded from the beginning of either
side.
¢ Al edit recording dose not perform when recording on an MD
player.
Use the remote control from steps 3 to 6.
1 Insert the tape into the connected tape deck.
2 Press the CD button and load the disc(s).
3 Press the EDIT/REMAIN button once.
"Al" flashes and "EDIT" lights up on the display.
Al EDIT
Each time it is pressed, the display changes as follows.
[" Al EDIT —> PRGM EDIT 1
4 Press one of the DISC DIRECT PLAY buttons to
select a disc.
5 Press the numeric buttons to designate the tape
length.
10 to 99 minutes can be specified.
Example:
When using a 60-minute tape, press the 6 and 0
buttons.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
* The <4
and »P® buttons are also available to designate
the tape length.
Remaining time
Tape length
of side A
Corte]
Selected tracks
for side A
Tape side A
(front side)
6 First set the connected tape deck to recording
mode, then press the P button on the remote
control to start CD play.
When recording on the front side (side A) ends, playback
stops. Repeat the procedure for side B. Be sure to fast-forward
or rewind the tape to start from the beginning of the side B.
To clear the edit program
Press the I button twice so that "Al EDIT" disappears on the
display.
To check the order of the programmed track numbers
Before recording, press the EDIT/REMAIN buiton to select side
A or B to be checked, and press the <4
or B®
button
repeatedly.
Programmed track
Program number
numbers
Tape side
Track number
To add tracks from other discs to the edit program
lf there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment .
1 Press the EDIT/REMAIN button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numeric buttons to select tracks.
A track which has a playing time longer than the remaining
time cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape ( with the minus
mark).
* Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
* The Al edit function cannot be used with discs containing 31
tracks or more.
ENGLISH 16
Advertisement
Table of Contents
