Aiwa AV-NW30, AV-NW31 Operating Instructions Manual

Aiwa av surround receiver operating instructions model av-nw30, av-nw31
Hide thumbs Also See for AV-NW30, AV-NW31:

Advertisement

AV SURROUND RECEIVER
RECEPTOR CON SISTEMA DE SONIDO PERIMÉTRICO PARA AUDIO-VÍDEO
RECEPTEUR AV SURROUND
AV-NW30
AV-NW31
Owner's record
For your convenience, record the model number and serial number (you will find them on
the rear of your unit) in the space provided below. Please refer to them when you contact
your Aiwa dealer in case of difficulty.
8C-AR6-903-21
020615CCK-H-S
Model No.
AV-NW30/AV-NW31
For assistance and information
call toll free 1-800-BUY-AIWA
U
(for HT-NW300, HT-DV2300)

OPERATING INSTRUCTIONS

MANUAL DE INSTRUCCIONES
Serial No. (Lot No.)
(United States and Puerto Rico)
MODE D'EMPLOI
En
(English)
E
(Español)
F
(Français)

Advertisement

Table of Contents
loading

Summary of Contents for Aiwa AV-NW30, AV-NW31

  • Page 1: Operating Instructions

    For your convenience, record the model number and serial number (you will find them on the rear of your unit) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. Model No.
  • Page 2: Important Safety Instructions

    ENGLISH WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. RISK OF ELECTRIC SHOCK DO NOT OPEN “CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
  • Page 3: Table Of Contents

    Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
  • Page 4: Preparations

    PREPARATIONS CONNECTIONS Before connecting the AC cord The rated voltage of your unit shown on the rear panel is 120 V AC. Check that the rated voltage matches your local voltage. IMPORTANT Plug in the AC power cord to the AC outlet after all other connections are made.
  • Page 5: Connecting Speakers

    1 and 2 in the illustration correspond to the following details. 1Sub woofer Right 1Surround speakers CONNECTING SPEAKERS 1 Speaker terminals Connect front speakers, a center speaker, surround speakers and a sub woofer to the corresponding speaker terminals on the unit: - the front speaker cords to the FRONT SPEAKERS terminals - the center speaker cord to the CENTER SPEAKER terminals...
  • Page 6: Positioning The Speakers

    POSITIONING THE SPEAKERS Position the speakers to make the most of Dolby, DTS or DSP surround effect. Front speaker (L/R) Center speaker (C) Position in the center of the two front speakers. In addition, position on or below the TV set, if connecting a TV set to the unit.
  • Page 7 Press FUNCTION repeatedly. The function changes cyclically. Operating AIWA equipment with the remote control You can control the basic functions of AIWA video recorder, TV, DVD player or CD player with the remote control. Note that there are models that cannot be operated with the remote control.
  • Page 8: Before Operation

    RANDOM while pressing SHIFT - Enters the random play mode. REPEAT while pressing SHIFT - Enters the repeat play mode. NOTE There are some AIWA models that cannot be operated with the remote control, or for which some of the functions of the remote control do not work.
  • Page 9: Sound

    SOUND CUSTOM AUDIO ADJUSTMENT MASTER VOLUME BALANCE MUTING MULTI JOG BASS TREBLE VOLUME CONTROL Turn MASTER VOLUME (press VOLUME +,-). Adjust from 0 (minimum) to 49 and MAX (maximum). Volume level setting is retained during power-off standby. If the unit is turned off with the volume set to 21 or higher, it is automatically turned down to 20 the next time the unit is turned Left and right balance of the front and surround speakers 1 Press BALANCE repeatedly.
  • Page 10: Basic Operations

    BASIC OPERATIONS SELECTION OF AUDIO/VIDEO SOURCE FUNCTION ENTER TUNING INPUT MODE 1 Turn FUNCTION to select the program source. The function changes in the following order. VIDEO 2 VIDEO 1 TAPE The actual source selected (except FM and AM) depends on the equipment connected to the input terminals on the rear panel of the unit.
  • Page 11: Recording An Audio Source

    WHEN THE “OVER LEVEL” INDICATOR LIGHTS UP When input analog signals from the connected equipment are too high to accept, the OVER LEVEL indicator lights up. In this case, adjust the input level so that the indicator disappears. To lower the sound level of the connected source When the analog sound level of the connected source is higher than that of the FM and AM functions, adjust it as follows.
  • Page 12: Radio Reception

    RADIO RECEPTION MANUAL TUNING ENTER MULTI JOG FUNCTION TUNING INPUT MODE POWER 6STANDBY/ON 1 Turn FUNCTION to select the desired band; FM or AM. 2 Press TUNING N N /M M to tune in a station. Alternatively, press j or l on the remote control. “TUNE”...
  • Page 13: Dolby Surround And Dts Surround

    DOLBY SURROUND AND DTS SURROUND This unit is equipped with the Dolby Pro Logic decoder, Dolby Digital decoder and DTS decoder. The unit and the center and surround speakers (standard) assure full-scale home theater sound. When playing back discs or video software that have been recorded in Dolby Pro Logic, Dolby Digital surround or DTS surround, astonishingly realistic sound surrounds the listener to create a new level of audio/visual...
  • Page 14: Setting Speaker Size And Distance

    SETTING SPEAKER SIZE AND DISTANCE ENTER MULTI JOG SPEAKERS Set the speaker size (large or small) and the speaker distance (distance between the speaker and the listening position), as well as speaker existance, correctly as described below. Default settings Default settings of the speaker size and distance are as follows: [AV-NW30] “FR LARGE”...
  • Page 15: Adjusting Speaker Level Balance

    ADJUSTING SPEAKER LEVEL BALANCE BALANCE The unit is equipped with a built-in test signal generator called a noise sequencer for easy balance adjustment of all five channels. The sequencer outputs a noise signal that “travels” from channel to channel, enabling the simple adjustment of sound level to achieve the same apparent loudness, at your listening position, from each channel.
  • Page 16: Other Settings

    OTHER SETTINGS ENTER MULTI JOG ADJUSTING LOW FREQUENCY SOUND EFFECT (LFE) The disc recorded in Dolby Digital surround contains special signals called LFE to enhance low frequency sound effect. The LFE signals are recorded in some particular parts on the disc and output from the connected sub woofer to reproduce astonishingly powerful low sound.
  • Page 17: Timer

    TIMER SETTING THE SLEEP TIMER MULTI JOG The unit can be automatically turned off at a specified time. 1 Hold down SHIFT and press SLEEP on the remote control. “SLEEP” is displayed. 2 Within 6 seconds, press JOG + + + + + or - - - - - repeatedly to set the sleep timer duration.
  • Page 18: Specifications

    SPECIFICATIONS FM tuner section Tuning range 87.5 MHz to 108 MHz Usable sensitivity 13.2 dBf (IHF) Antenna terminal 75 ohms (unbalanced) AM tuner section Tuning range 530 kHz to 1710 kHz (10 kHz step) 531 kHz to 1602 kHz (9 kHz step) 350 µV/m Usable sensitivity Antenna...
  • Page 19: Parts Index

    PARTS INDEX Instruction about each part on the unit or remote control are indicated on the pages listed (in alphabetical order) below. On the unit BALANCE 9, 15 BASS DIMMER ENTER 6, 7, 10, 12, 14, 16 FUNCTION 10 - 13 INPUT MODE 10 - 13 MASTER VOLUME...
  • Page 20 Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product. For assistance and information ENGLISH Printed in China call toll free 1-800-BUY-AIWA (United States and Puerto Rico)

This manual is also suitable for:

Av-nw31Ht-dv2300Ht-nw300Panini xlPanini xle

Table of Contents