Advertisement
Operation
The set up and measurement procedure is as follows:
1. Set the cable length to 0m.
2. Connect the 16034E directly to the UNKNOWN terminals.
3. Loosen the knob A.
Figure 1-2
4. Adjust the contact pin position on the V-mount center section with the knob B
to adapt your DUT size.
Figure 1-3
5. Tighten the knob A to fix the contact pin.
6. Make the right and the left contact pins contact.
7. Perform the short compensation described in the instrument's operation
manual.
8. Pressing the loading lever C to left.
9. Hold the lever C so that the gap of contact is as same as the DUT's length.
Chapter 1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Operation
Operation
11
Advertisement
