Table of Contents
Advertisement
OPERATION
The RD-1000 has mainly two modes, Function and
Edit. In the Function mode, you can call a voice or
a parameter, and in the Edit mode, the value of the
parameter you have called can be edited. To
change the modes, use the Function Button
@ and
Edit Button @. The corresponding indicator lights
up to tell you which mode is currently selected.
1. Basic Operation
After making all the necessary connections, turn
the amplifier's volume to zero, then switch on the
Power Switch @ on the Pedal Unit.
The Display @ will react as shown below.
If you find it difficult to see the Display, adjust the
contrast with the Contrast Knob @.
a. Voice Selection
The RD-1000 retains 64 tone colors: 8 basic voices
and other 7 variations for each voice. To call a
voice you like, use the Voice Selector Buttons 1 to
8 and the Bank Button.
VOICE | PIANO
|
VOICE 2. PIANO
2
VOICE 3 PIANO
3
VOICE 4
HARPSICHORD
VOICE 5
CLAVI
VOICE 6
VIBRAPHONE
VOICE 7
E.PIANO
|
VOICE 8
E.PIANO
2
8 different sounds
are preprogrammed
in the
voices 1 to 8 of Bank 1. Each voice has another 7
variations
(Bank 2 to 8). That is, there are alto-
gether 8 variations for one voice.
To select the basic voice 1 to 8 in the Bank 1, push
the relevant Voice Selector @.
Push the appropriate Voice Selector
To select other variation of that voice, hold the
Bank Button @® down and push the corresponding
Voice Selector Button. Here, the Voice Selector
Buttons 1 to 8 correspond to the bank numbers.
VOICE SELECTOR
WRITE
=
oa
=
So
a
CJ Co
Sa od a ps a oa
i
@
®
@ While holding the
Bank Button
@ Push the appropirate
Voicde Selector (1 to 8)
Advertisement
Table of Contents
