Table of Contents
Advertisement
[1] PANEL DESCRIPTION
<Front Panel>
@ External Volume Knob
@ Volume Knob
© ¢@ Dial
Q Display
@ Parameter Indicators
@ Contrast Knob
@® Voice Selectors
® Tremolo/Load
@ Program Change Button
Button
@ Key Transpose Button
@ Chorus/Save
© Tune Button
Button
@ Function Button
@® Bank/Write Button
@ Edit Button
IMPORTANT NOTES
Power Supply
Power Cord
®@ The appropriate voltage to be used is shown on
When disconnecting the power cord from the soc-
the name plate on the rear panel. Be sure that
ket, do not hold the cord but the plug. When the
the requirement meets the voltage system in
unit is not to be used for a long period, disconnect
your country.
the power cord.
@ Do not use the same socket that is used for any
noise generating device, such as a motor, or
Location
variable lighting system.
e When setting up the RD-1000, be sure that all
e@ Operating the RD-1000 near a neon or fluores-
the units are turned off.
cent lamp may cause noise interference. If so,
change the angle or position of the RD-1000.
@ This unit might not work properly if the power
cable is plugged in with the unit turned on. If
this happens, simply turn the unit off, and turn
it on again in a few seconds.
® This unit might slightly generate
heat while
operating, but there is nothing to worry about it.
@ Avoid
using the RD-1000 in extreme
heat or
humidity or where it may be affected by dust.
Advertisement
Table of Contents
