Roland RD-1000 Owner's Manual page 16

16
When the saving is completed, the Display
responds with:
@ Return the Memory Protect Switch on the
Memory Cartridge to the ON position.
If the Memory Protect Switch has not been set to
the OFF position, the Display will react as shown
below and the saving cannot be done.
If this happens, set the Protect Switch on the
Memory Cartridge to the OFF position, then repeat
the saving procedure.
2) Loading
@ Securely connect the Memory Cartridge to the
Memory Cartridge Holder @ on the front pane!
with the Protect Switch side facing upward.
* The loading procedure should be done with the
Protect Switch on the Memory Cartridge set to
the ON position.
@ While holding the Load Button @® down, push
the Write Button. —
WAITE SAVE Loan
oa co
ff Poca
cHonus tril [Lo
@ @
@ While holding the Write
Button down.
@ Push the Load Button.
When the loading is completed, the Display
responds with:
If you want the Preset voices at this stage, turn
the RD-1000 off, then on. The Preset sounds will
be called in the Bank 1.
If you try to save or load without the Memory Car-
tridge connected, the Display will react as shown
below.
NOTE
When connecting or disconnecting the Memory
Cartridge, be sure that its Protect Switch is set to
the ON position. If not, the data saved on the
memory Cartridge may be erased.