Error Message List - Roland RA30 Owner's Manual

Chapter 6 Reference
© Did you change the range for Style Play?
You will not be able to carry out Style Play if the range for Style Play is not set properly.
(p41)
If you are using an electronic piano, you will not be able to obtain Style Play if the range
for Style Play that has been set lies outside the range of the keyboard.
If connected with an acoustic piano, remember that the range output by the KP-24 is C1-
B2. You will not be able to obtain Style Play if the range for Style Play has been set to a
range different than that of the KP-24.
@ | can't add an intro.
© Press the Intro/Ending button to make the button light flash before starting the perfor-
mance ({p.26}.
@ The timing of a Fill-in is off.
© Press the To Original or To Variation button for Fill In right before the place where the
Fill-In is to be inserted (p.33).
@ The timing of an ending is off.
© An ending starts on the first beat of the next measure after the Intro/Ending button is
pressed (p.33}.
@ Error Message List
When an error occurs, an error message flashes on and off in the display.
EU
eof OS
a
Problem: The batteries are low.
Response : Contact your nearest Roland Service Station.
Mm
U
o> SO
a
Problem : A MIDI or RRC cable has been disconnected, or is otherwise causing commu-
nication problems.
Response : Check the MIDI or RRC cable connections.
Mm
Mu
i]
[a]
Problem : The RA-30 has received a batch of MIDI data that is too large to process.
Response : Reduce the amount of MIDI data being sent to the RA-30 at one time.
Mm
U3
Problem : There is too much performance data to allow further recording, and so
recording has stopped.
Response : Reduce the amount of performance data to be recorded on the RA-30. If a
MIDI keyboard is connected, use of the pitch bender in particular can create
enormous amounts of data, so you may need to reduce pitch bender use.
49