Table of Contents
Advertisement
4. The zoom lens is restored automatically.
• Did you leave the camera with the power switch on
and not operate it for over three minutes? If so, the
camera switches off the power automatically and
stores the lens in the lens cover to protect it. (See
page 4.)
5. When the power is switched on, the zoom
lens automatically extends itself.
• The camera holds in memory for approx. 30 minutes
the settings before the power was automatically
switched off. Therefore, switching the power back on
within 30 minutes restores the previous shooting state
automatically.
6. The flash emission mark (llii;) is flickering
on the LCD panel.
• Did you just use the Flash-Off or the Backlight
Compensation modes in a dark place? This is a
warning against underexposure. You cannot take a
well-lit picture while this mark is flickering. (See
pages 25 and 26.)
• The correct camera-to-subject distances when flash
shooting is employed using films other than ISO 100, 200
or 400 are indicated in the table below.
nB!H
■HI
50
1000
1600
rim
{|3IQ
MWj
-
1.35'-12m
Macro (
O
i
-
-
Super I
Macro
0.45 m )
©
IH
-
-
-
* Because of high film speed, overexposure may occur at
close range.
—: Correct exposure cannot occur.
Advertisement
Table of Contents
