Table of Contents
Advertisement
Notes:
• When the flickering data on the date indicator is being
corrected, it cannot be imprinted even if the shutter is
released.
• Date and time are indicated as follows:
Year^ 87- 19(1987-2019)
Month - 1 - 12
Day -- 1 - 31
Hour - 0 - 23
Minute = 00-59
• The flickering ■:" allows precise fine-tuning of the
internal clock to the beginning of a specified minute.
To do so, press the 'SELECT" button^ until
will
flicker. And press the ADJUST button© in sync with
a time-signal.
Date imprinting:
The (Year-Month-Day) or (Day-Hour-Minute) data is
recorded on film as in the picture on page 37. The data on
the date indicator is imprinted on each frame you expose.
Notes:
• If the corner of the picture has a white or yellow object,
the imprinted data will be difficult to see. When
composing, try to avoid a brightly colored subject in
that corner.
• "Year-Month-Day" and "Day-Hour-Minute" cannot
both be imprinted at the same time.
• As you release the shutter, the bar mark ( — } on the
date indicator flickers for a few seconds, indicating the
data has been imprinted.
Power source of the data-imprintlng section
The data imprinting section is powered by the
batteries in the camera's main unit. When the batteries
are replaced, the date and time may change. So, after
replacing the batteries, make sure to confirm the date and
time before use.
• Refer to page 38 for data correction.
Advertisement
Table of Contents
