Setting data
I Year-Month-Day
|
»| Day-Houf-Minute |
t
i
I
i
I
Day-Month-Year ~|-f
|
Month-Day-Year ]
Switching the mode
Each time you press the MODE button O with your
fingernail, the data mode on the date indicator switches in
succession as shown in the chart Stop pressing the
button when the desired data mode appears on the date
indicator
. indicates no data will be imprinted.
Correcting the data
1. Each time you press the SELECT button 0. a different
category of digits on the date indicator flickers. Press
the SELECT button 0 until you reach the flickering
digitls} which you wish to change. The digitls) will cycle
in the following order as you press the SELECT button
e
Date Year
• Month • Day
Time Hour • Minute *
(Second)
2 Press the ADJUST button o to change digits within the
specified category chosen. Digits increase by one each
time you press the ADJUST button
0
.
If you hold down
the button, the digit will advance continuously after two
or three seconds.
3 After the adjustment is made, press the SELECT button
e The bar mark | — ) appears on the date indicator,
indicating that data imprinting choices are possible.
Notes:
• M on the date indicator indicates Month
• Use the strap tool s pin-shaped protrusion (
|
(see page 3) to press the SELECT
0
and ADJUST
o
buttons