Solid-State Drive (M.2) - HP ZBook Studio G5 Maintenance And Service Manual

Solid-state drive (M.2)

Description
2-TB, TLC
1-TB, TLC
1-TB, MLC
512-GB, TLC
512-GB, self-encrypting drive (SED), OPAL 2, TLC
512-GB, FIPS, TLC
256-GB, TLC
256-GB, PCIe, self-encrypting drive (SED), OPAL 2
256-GB, SATA-3, self-encrypting drive (SED), OPAL 2
Optane memory module, 16-GB
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Lift the Mylar from atop the solid-state drive.
2. Remove the Phillips M2.0×3.0 screw (1) that secures the solid-state drive to the system board.
Bottom cover on page
Battery on page 35).
33).
Component replacement procedures
Spare part number
L28681-001
L28677-001
L28685-001
L28683-001
L28682-001
L28684-001
L28679-001
L28678-001
L28680-001
L28676-001
37