JVC HD-ILA HD-61Z585 User Manual page 69

Please read these
instructions fully before attempting to replace the _amp. If you feel
unsure about replacing the lamp yourself, call a service technician. Please observe all
safety warnings.
1) Turn off the television,
Press the POWER button on the remote controt or TV front panel. Wait until the picture has
closed and the LAMP LED on the front panel has stopped blinking indicating the lamp cool
down is complete.
Warning: The coo_=down process coo_s the lamp from its operating temperature. TMs
does not mean that the lamp wH_ now be cool enough to handle safe_y. We strongly
recommend you wait at leaet one hour before proceeding.
2) Unplug the television.
Disconnect the power cord from the AC outlet. Make sure that the LAMP LED light has stopped
biinking before you unplug the set. Never attempt to replace the tamp with the television
ptugged in.
3) Remove a screw from the rear panel
Next you must remove one screw from the rear panel. The screw is located
under the right rear panet. You will need to remove the screw with your
fingers.
4) Remove the left speaker panel
Next you must remove the left speaker panel located at
the bottom of the front panel. To remove the panel, grab
the panel and pull the bottom away from the television,
pulling it towards you. The panel witt come away from
the bottom of the TV. Set the panel aside.
Note:
• When removing the speaker panet, in order for the
speaker not to fall, hold the speaker panet securely by
the hand, pulling the set slowly in front, and remove.
5) Remove the lamp cover.
The lamp is tocated behind the tamp cover. To access
the lamp you will need to remove the lamp cover. First,
loosen the screw located on the lamp cover using your
fingers. Once the screw has been loosened, gently putl
the knob towards you and the panet wilt come away from
the television. Set it aside.