Troubleshooting - Pioneer PD-7500 Operating Instructions Manual

Table of Contents

Advertisement

i
TROUBLESHOOTING
|
28 being used,
center or your
Symptom
Cause
Remedy
/ Disc tray is not expelled
when OPEN/CLOSE
but-
ton @ is pressed.
Power plug is disconnected from
outlet.
POWER switch @ is OFF.
Connect plug to stereo-emplifier
or wail outlet.
Press POWER switch @ ON.
| When
playback is start-
| ed, it stops immediately.
Pauses or stops
playback
Disc is loaded upside down.
Smudges
on the disc, etc.
Load the disc correctly with the label side UP.
Clean the smudges from the disc and then play
it again.
No sound,
Output cords are connected
incorrectly or
loosely,
Incorrect operation of stereo amplifier.
Player is in pause mode.
Connect properly.
Check the settings of stereo amplifier switches
and sound volume controls.
Press PLAY button @,
Sound is distorted, noise
is output.
incorrect connections.
Pin plugs or amplifier input terminals are dirty.
Interference is being picked up from a TV set.
Connect to amplifier's CD or AUX terminals
etc.
Do not connect to PHONO
input terminals,
Clean away dirt.
Switch OFF TV set, or move player away from
TV set.
With certain discs, loud
noise is produced, or
play stops.
Disc is badly scratched or warped.
Disc is extremely dirty.
Replace the disc.
Clean disc.
Cannot operate player
with remote control unit.
Batteries have expired.
Remote control unit is too far away from play-
er, or angle is wrong.
There is an obstracle between remote control
unit and player.
Replace batteries.
The operating range of the remote control unit,
is up to about 7 m from, and within angles of
30 degrees left and right of the sensor window
on the player.
Operate the remote control unit from a differ-
ent position, or remove the obstacle.
18
<PRB1127>
En

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pd-6500

Table of Contents