Table of Contents
Advertisement
Installing the flat nozzle
Optional accessory
NOTE: If the end nozzle is installed, remove it before
installing the flat nozzle.
1.
Align the groove on the adapter pipe with the pro-
trusion on the front pipe, then attach the adapter pipe to
the front pipe, and then turn it to lock it into place.
Fig.3
► 1 . Adapter pipe 2. Front pipe
2.
Align the groove on the flat nozzle with the protru-
sion on the adapter pipe, then attach the flat nozzle to
the adapter pipe, and then turn it to lock it into place.
1
Fig.4
► 1 . Flat nozzle 2. Adapter pipe
1
FUNCTIONAL
DESCRIPTION
CAUTION:
is switched off and the portable power pack is
disconnected from the machine before adjusting
or checking function on the machine.
Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend machine and battery life.
The machine will automatically stop during operation if
the machine or battery is placed under one of the fol-
lowing conditions:
Overload protection
2
When the machine or battery is operated in a manner
that causes it to draw an abnormally high current, the
machine automatically stops and the speed indicator
blinks in green. In this situation, turn the machine off
and stop the application that caused the machine to
become overloaded. Then turn the machine on to
restart.
Overheat protection
When the machine or battery is overheated, the
machine stops automatically. When the machine is
2
overheated, the speed indicator lights up in red. When
the battery is overheated, the speed indicator blinks
in red. Let the machine and battery cool down before
turning the machine on again.
Overdischarge protection
When the battery capacity is not enough, the machine
stops automatically and the speed indicator blinks in
red. In this case, remove the battery from the machine
and charge the battery or change the battery to fully
charged one.
Protections against other causes
Protection system is also designed for other causes that
could damage the machine and allows the machine to
stop automatically. Take all the following steps to clear
the causes, when the machine has been brought to a
temporary halt or stop in operation.
1.
Turn the machine off, and then turn it on again to
restart.
2.
Charge the battery(ies) or replace it/them with
recharged battery(ies).
3.
Let the machine and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.
NOTICE:
not described above, refer to the section for
troubleshooting.
8 ENGLISH
Always be sure that the machine
If the machine stops due to a cause
Advertisement
Table of Contents
