Table of Contents
Advertisement
Maintenance and Adjustment
Should the battery voltage fall below 12.7
Volts, the battery should be charged
using
a
Triumph
charger. Always remove the battery
from the motorcycle and follow the
instructions supplied with the battery
charger.
For extended periods of storage (beyond
two weeks) the battery should be
removed from the motorcycle and kept
charged using a Triumph approved
maintenance charger.
Similarly, should the battery charge fall
to a level where it will not start the
motorcycle, remove the battery from
the motorcycle before charging.
Battery Installation
Warning
Make sure that the battery terminals
do not touch the motorcycle frame as
this may cause a short circuit or spark,
which would ignite battery gases
causing a risk of personal injury.
Street Twin, Street Cup,
Street Scrambler, Bonneville T100
and Bonneville T120
Place the battery in the battery case.
Re-install the USB port socket and
secure with the battery strap.
Reconnect the battery, positive lead
(identified with red tape) first.
Tighten
the
battery
40 lbf in (4.5 Nm).
Apply a light coat of grease to the
terminals to prevent corrosion.
Cover the positive terminal with the
protective cap.
128
approved
battery
terminals
to
Place the ECM unit in its original
position.
Reconnect the brake/tail light and
accessory cables.
Re-install the fastener to secure the
ECM unit.
Re-install the seat (see page 62).
Thruxton and Thruxton R
Place the battery in the battery case.
Secure with the battery strap and make
sure the USB port socket is re-installed.
Reconnect the battery, positive lead
(identified with red tape) first.
Tighten
the
battery
40 lbf in (4.5 Nm).
Apply a light coat of grease to the
terminals to prevent corrosion.
Cover the positive terminal with the
protective cap.
Re-install the seat (see page 62).
terminals
to
Advertisement
Chapters
Table of Contents
