Table of Contents
Advertisement
NOTE: When installing new battery, ensure the battery is label side up.
5. Position new battery on thermal pad as shown.
6. Connect the battery wiring harness to the PC board.
7. Install inlet filter with tubing into holder.
8. Re-assemble the XPO
Re-assembling the XPO
NOTE: For this procedure, refer to FIGURE 2.3 on page 10.
1. Carefully, re-install the front cover onto the XPO
2. Turn the XPO
On to ensure proper operation.
2
3. Turn XPO
Off.
2
4. While holding the unit together, position the XPO
(Detail "A" in FIGURE 2.3).
5. Install four mounting screws and secure the two sections of the XPO
"A" in FIGURE 2.3). Securely tighten.
6. Remove the glue residue by applying 91% isopropyl alcohol, and wiping with a clean
cloth. Make sure the surface is dry and free of any residue. This will ensure a good seal
for the new label.
7. Install replacement label on the top of the XPO
rear sections.
Replacement Parts
NOTE: Refer to the parts catalog at www.invacare.com for component part number.
Part No 1150748
SECTION 2—COMPONENT REPLACEMENT
. Refer to Re-assembling the XPO
2
2
13
on page 13.
2
.
2
so that the back panel is facing up
2
so that it adheres to both the front and
2
together (Detail
2
™
XPO
2
Advertisement
Table of Contents
