Invacare XPO2 XPO100 Service Manual page 10

SECTION 2—COMPONENT REPLACEMENT
1. Remove label from the top of the XPO
NOTE: This label adheres to the front and rear sections of the XPO
to separate the two sections.
2. Position the XPO
3. Remove the four mounting screws from the back of the XPO
screwdriver (Detail "A" in FIGURE 2.3).
DETAIL "A"
Ribbon Cable
™
XPO
2
FIGURE 2.2 Remove/Install label
so that the back panel label is facing up (Detail "A" in FIGURE 2.3).
2
Mounting Screws
Back Panel Label
Mounting Screws
Front Cover
DETAIL "C"
PC Board
FIGURE 2.3 Removing the Front Cover
(FIGURE 2.2).
2
. This label MUST be removed
2
Front Cover
Tubing
10
Label
XPO
2
®
using a T15 Torx
2
DETAIL "B"
Ribbon Cable
Inlet Filter
Part No 1150748