Chapter 1: Introduction; Before You Start - Biostar BIELK-PAT User Manual

Table of Contents

Thank you for choosing our product. Before you start installing the motherboard, please make sure you

follow the instructions below:

• Prepare a dry and stable working environment with sufficient lighting.

• Always disconnect the computer from power outlet before operation.

• Before you take the motherboard out from anti-static bag, ground yourself properly by touching

any safely grounded appliance, or use grounded wrist strap to remove the static charge.

• Avoid touching the components on motherboard or the rear side of the board unless necessary.

Hold the board on the edge, do not try to bend or flex the board.

• Do not leave any unfastened small parts inside the case after installation. Loose parts will cause

short circuits which may damage the equipment.

• Keep the computer from dangerous area, such as heat source, humid air and water.

• The operating temperatures of the computer should be 0 to 60 degrees Celsius.

• To avoid injury, be careful of:

Sharp pins on headers and connectors

Rough edges and sharp corners on the chassis

Damage to wires that could cause a short circuit

Note

» » The package contents may be different due to the sales region or models in which it was sold. For more

information about the standard package in your region, please contact your dealer or sales representative.

Chapter 1: Introduction

BIELK-PAT User's Manual

Chapter 1: Introduction | 3

Table of Contents