Installation Installation Installation NOTICE NOTICE NOTICE Overtightening the spray tip (5) can damage the tip and cause poor spray performance. To reduce the risk of injury, follow the Pressure Pressure Pressure 5. Install the spray tip (5) and tighten using the Relief Procedure Procedure in your Pro Xp manual before Relief...
Parts Parts Parts Parts Part No. No. Description Description Ref. Ref. Ref. Part Part Description 236768 DIFFUSER/SEAL ASSEMBLY; includes item 183459 SEAL; UHMWPE 24R776 RETAINER, large (shown) 24R775 RETAINER, small (not shown) 245294 AIR CAP/ELECTRODE ASSEMBLY; includes item 198748 ELECTRODE 236xxx TIP ASSEMBLY;...
Spray Pattern Troubleshooting Spray Pattern Pattern Troubleshooting Troubleshooting Spray Spray Pattern Troubleshooting NOTE: NOTE: NOTE: Some spray pattern problems are caused by the improper balance between air and fluid. Problem Problem Problem Cause Solution Cause Cause Solution Solution Spray is too forceful (high velocity). Air flow too high.
Page 5
Round Spray Tips Round Spray Spray Tips Tips Round Round Spray Tips Part Part Part No. Size Size No. Size Approximate Approximate Approximate Flow Flow Flow Rates Rates for Rates for Light Light to to to Medium Light Medium Viscosity Medium Viscosity Viscosity Coatings...
Page 6
Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. However, any deficiency in the barrel, handle, trigger, hook, internal power supply, and alternator (excluding turbine bearings) will be repaired or replaced for thirty-six months from the date of sale.